|Manufacturer’s Warranty||1 year Limited Warranty|
|Impeller Material||Cast Iron|
|Port Size (in.)||3″|
|Max Flow (GPH)||16020|
|Motor||Kohler gasoline engine SH265|
|Working Range||@ 70ft. > 1620 GPH
@ 33ft. > 16020GPH
|Max. Suction Lift (ft.)||17|
|Suction Port (in.)||3″|
|Discharge Port (in.)||3″|
|Portable||Yes – 2 WHEELS TROLLEY WITH HANDLES|
This serie of electric centrifugal self-priming pumps has the characteristics to have the prime made by means of the emulsion air-liquid. The air of the suction piping is sucked inside the pump body by the depression created by the rotating impeller, therefore it emulsifies with the liquid contained into the pump body.
The emulsion air-liquid is pushed into the delivery channel where the air, which is lighter, gets separated and gets out from the delivery piping; the liquid, which is heavier, returns into circulation. Once the pump gets rid of all the air from the suction piping, the pump starts and it works as a normal centrifugal pump, therefore
the pump can work also with a mixture of air-liquid. There is a non-return valve fitted to the discharge side which enables a small quantity of liquid to be retained in the pump body thus allowing an automatic prime and suction lift to any application. This eliminates the need to prime the pump at each start up.
The centrifugal sel-priming pumps series JCS have been designed to be flanged (or through a flexible coupling) to diesel or gasoline engines
and electrical motors.
These groups are then suitable for heavy duty application with solids handling, for this series of pumps are the following:
Building industry : Drainage of excavation sites, dewatering of floods. Water transfer to/from tankers.
Treatment : Transfer of dirty and dewage waters, emptying of domestic or industrial drain wells.
Ship industry : Bilge dewatering, washing, water transfer.
Civil industry : Transfer of muddy, chemical liquids with solids and particles in suspension. Fire-fighting. Sewerage system drainage.
Agriculture : Irrigation at low and middle pressure head.
Pump body, impeller, pump support and inlet in cast iron
Non return valve in nitrile rubber and steel
Impeller cast iron
Mechanical seal in carbon ceramic (upon request tungsten/carbide)
Rotor shaft in stainless steel fitted with seal bearings
Totally enclosed fan cooled motor (TEFC)
Single phase motors with a built in thermal overload protection
on request, the capacitor is permanently in circuit
Winding Insulation to class F.
PUMP PERFORMANCE DATA
– Capacities up to 323 ft3/hr
– Maximum Temperature of pumped liquid -15°C to 70°C
– Maximum ambient temperature 40°C
– For higher temperatures please contact the sales office
- 6.5 HP
Maximum working pressure 6 bar
The tolerances of the hydraulic features are according to
UNI/ISO 2548-Class C, Appendix B, motors according to C.E.I.
The working features listed in the catalogue are based on continuous
service for clear water with a specific weight of
Manometric suction lift of 8 meters maximum.
Upon installation always prime the pump body first before start up. Pump must be installed always in the horizontal position.